USB to RS232 TTL | CMOS Adapter Cable with Terminal Block
$32.95
The new USB to RS232 TTL adapter allows you to control your voltage setting as you need whether 3.3V or 5V is needed. Dip switch controls are located at the RS232 terminal block for easy access to your voltage setting.
USB to RS232 TTL voltage settings just got easier!
Up until now you’ve had to make a choice between USB to TTL adapters and their voltage with either or selections. This USB to RS232 TTL/CMOS adapter cable eliminates that by allowing you to choose a voltage setting right at the adapter’s connection point at the terminal block.
The USB-2323TTLMOS provides a USB to RS232 port with 5V/3.3V/2.5V/1.8V TTL / CMOS compatible Logic levels. The RS232 signals include TXD, RXD, and GND. The RS232 TTL cable is USB bus powered and does not need any DC power from an external AC Power Adapter. The TTL /CMOS RS232 signals are processed on the 5-pin Terminal Block.
Configuration for terminal block
Pin 1 TXD (Output)
Pin 2 RXD (Input)
Pin 3 VOUT (Output TTL / CMOS Power)
Pin 4 VIN (Input TTL / CMOS Power)
Pin 5 GND (Ground for TTL / CMOS)
Product Features
Provides 1 TTL/CMOS RS232 Serial Port over USB Port
Supports a 5-pin Terminal Blocks for TTL/COMS Signal Wiring
5V/3.3V/2.5V/1.8V Logic Level Selectable by DIP Switch
Signal Levels are Similar to Standard RS232 but in TTL/CMOS Swing Level
Easy Serial Port Expansion over USB Port
USB1.1 and USB2.0 Forward Compatible
Built-in FTDI USB UART Chip
Supports Serial Speed from 300bps to 921.6Kbps
Supports 7,8 Data Bits
Odd, Even, Mark, Space, None parity mode
Supports 1, or 2 Stop Bits
Supports XP, CE, 2000, 2003, 2008 Win 7, Vista, Win 8, 10 Linux and Mac OS
Specifications
Fully compatible with USB 1.1 and forward compatible with USB 2.0
Form Factor
1.77”(L)x1.65”(W)x1.15”(H) (4.49 x 4.18 x 2.20 cm)
TTL / CMOS Serial Port
Supports one 5-pin Terminal Block TTL / CMOS RS232 Serial port snd the key benefits are:
Logic Levels: Selectable by a DIP Switch
Data Bits: 7, 8
Stop Bits: 1, 2
Parity: None, Odd, Even, Mark, Space
Baud Rate: 300bps to 921.6Kbps
Power Requirements
USB Bus Powered, no External Power Supply Needed.
+2.5V or +1.8V DC Power Input Required on the 5-pin Terminal Blocks in case of Supporting 2.5V or 1.8V Logic Levels